|
|
Foam Rod
45kg closed cell circular foam rod use in expansion joints.
Alternatively it can be used as groutcheck foam, particularly around precast elements.
 |
| DIMENSIONS (MM) |
SIZES |
| 6mm |
1500m |
CTN |
20mm |
300m |
CTN |
| 10mm |
1100m |
CTN |
25mm |
200m |
CTN |
| 12mm |
900m |
CTN |
30mm |
150m |
CTN |
| 15mm |
500m |
CTN |
40mm |
80m |
CTN |
|
Flexcell
Flexcell is a sheet of compressed wood fibres impregnated with bitumen emulsion. It is used as a general expansion joint filler in concrete slab and wall construction.
| Sheet Size |
Thickness |
| 2.3 x 1.22m |
12mm |
| 2.3 x 1.22m |
20mm |
| 2.3 x 1.22m |
25mm |
|
Jointstrip
A fast efficient, cost effective system for all brick and concrete expansion joints. It comes ready to use in a variety of sizes with the top edge pre-cut for stripping.
Miothene
Miothene 70 is a continuous chemically cross-linked closed cell semi-rigid polyethylene joint filler designed for forming critical movement/expansion joints in concrete, brickwork and blockwork. It is light, clean and easy to use, rot-proof, non-absorbent, resistant to most chemicals and oils, non-staining and has high weathering and ozone resistance.
Miothene 70 is available in sheets of 2m x 0.8m and thicknesses of 10mm, 20mm, 25mm. |
Slip Membrane
A slip membrane produced from ultra-heavy density polyethylene, 2mm in thickness. It is used in sliding joints where low friction resistant material is needed, but a high resistance to load is also required. Normally used in two layers therefore to form a low friction load bearing sliding joint.
Available in 25m rolls cu to any width up to 800mm.
Bitucork
Bitucork is a robust, bitumen impregnated cork filler board which will not extrude under load. Like all 'Texell' foam filler boards it is waterproof, rotproof and resistant to most chemicals and alkalis. It has a high impact resistance, particularly against abrasive materials making it suitable also as a protection board.
Applications:
Water retaining and basement structures, sea defences and structural movement joints.
Compliant with ASTM D1751 requirements.
Bitucork is availabe in sheet sizes 2.14m x 914mm and the following thicknesses: 10mm, 12mm, 20mm, 25mm |
Cork-tex
A resin bonded cork fillerboard used in water retaining structures such as water treatment and sewerage plants, sea walls and reservoirs etc.
Compliant with ASTM D1745, Type 2.
Cork-tex is available in sheets of 610mm x 915mm and thicknesses of: 12mm, 20mm, 25mm |
|
